Inspired by Alfonso's Midichord module and my needs I decided to create my first ever Modular2 patch. It's a midi chorder as shown on the following pictures:


The routing is ok I belive. Please, observe the 4th to 7th keyZone modules are set to 1 (the lowest available) key. It's because in the preset (Major chord) only the first 3 keyZone modules are necasary and I found this the only method of muting the modules (perhaps there are any other?)
However I encountered some annoying problems:
SP 4.0
After creating the patch I saved it and wanted to remove it from the project - a question appeared 'save the patch as a new device' (again!!!).

I rebooted Sp4 and loaded my patch. I discovered the midi out module showed nothing


SFP 3.1c
I created the same patch from scratch thinking it was the Sp4 bug. And... right after connecting it to a synth (polyphony set to 12) I've heard ONLY one note... I decided to load the patch created in Sp4 and it worked! So I removed the Sp4 patch and loaded the SFP3.1c patch again and... it worked as expected!!!
Back in SP4.0
I loaded the SP4 patch and, of course it had no midi out. I removed it and loaded the SFP3.1c patch and it worked! I removed it and loaded the Sp4 patch again and... it worked (the midi out worked!)
Other annoyeances:
- while removing the SP4 patch I get ALWAYS (no matter I do anything to the patch or don't touch it) the question 'save the patch as a new device'!!!! The question doesn't appear while removing the SFP3.1c patch from within SP4!!!!
Please, help me explaining the phenomenon or it's just a bug

P.S.
I work on a Mac
_________________

<font size=-1>[ This Message was edited by: samplaire on 2004-07-02 10:47 ]</font>
<font size=-1>[ This Message was edited by: samplaire on 2004-07-02 10:48 ]</font>