01V96

Yorkeire · Post by **Yorkeire** » Tue Apr 06, 2004 7:05 am

Can anyone give me some help regarding the Yamaha 01V96. I have just purchased this mixer and have a few questions that are confusing me. Please dont laugh as this is my first digital mixer. Here I go!!!

1. To connect my hardware synths to my pulsar and 01V, do I need a Ultra A16/Luna

2. Do I only need to connect through my optical I/O and midi? (how does word clock, connect and work?)

I will try and be more specific if someone replies, I am a complete novice with digital mixers so please be gentle

Cheers in advance

virtualstudio · Post by **virtualstudio** » Tue Apr 06, 2004 7:29 am

do you have pulsar II?
than the easyest way (what I do) is connect trough adat.

about wordclock I use scope as master and 01v as slave(most of the time)

there is no need to connect truogh midi but it can be very handy

virtualstudio · Post by **virtualstudio** » Tue Apr 06, 2004 7:37 am

for wordclock remember to put your speaker on very low volume!!

go to set-up page 1
select auto navigate
you get message confirmation select ok press enter

make sure pulsar is set to master
take any sound source and connect to adat dest.

Yorkeire · Post by **Yorkeire** » Tue Apr 06, 2004 7:44 am

Cheers Virtualstudio, when I connect to wordclock do I connect from the digital phono connectors to wordclocks BNC connectors.

Sorry if I sound dumb its my first time using a digital mixer (P.S. yes it is a Pulsar II)

<font size=-1>[ This Message was edited by: Yorkeire on 2004-04-06 08:45 ]</font>

virtualstudio · Post by **virtualstudio** » Tue Apr 06, 2004 8:01 am

????? that I don't understand.
I Would connect my hardware synth's just into 1 of the channels, then through adat to pulsar, pulsar back trough adat into the 01v and then your 01v stereo out to amp and speakers.

btw I have 01v48 wich is a bit different