monitoring fx

Jah Servant · Post by **Jah Servant** » Tue Apr 26, 2005 6:36 pm

I can't seem to get to any fx out of the monitor outputs.
How is it done?

Post by **garyb** » Tue Apr 26, 2005 6:42 pm

return the fx to a channel and then send that channel out the monitor, just like you would with a real mixer.

Music Manic · Post by **Music Manic** » Tue Apr 26, 2005 8:04 pm

fx are routed to mix outs.

Jah Servant · Post by **Jah Servant** » Tue Apr 26, 2005 8:16 pm

ok then so what is the MnL&R effects returns for?
I thought that these route to the monitor outs and you'd just send the effects out to them as well as to your regular returns for the main mix, no?

Post by **garyb** » Tue Apr 26, 2005 9:16 pm

you can do it that way...check the rtn page on the master channel strip. is the aux to mon mute enabled?

Jah Servant · Post by **Jah Servant** » Tue Apr 26, 2005 10:11 pm

I tried turning it off, by default it's on, but still the fx doesn't come through, that's what I don't understand.

beerbr · Post by **beerbr** » Tue Apr 26, 2005 11:16 pm

Check out if there is input signal at your effect?? May be that you forget to turn the aux send enable.. (make it ON [light green] at the channel stripe of your track)

<font size=-1>[ This Message was edited by: beerbr on 2005-04-27 00:19 ]</font>

Jah Servant · Post by **Jah Servant** » Wed Apr 27, 2005 7:12 am

that's not it, the meter's move on the mon fx return, so there is a signal there, it just doesn't go to the monitor outs for some reason.
plus the fx come out of the main mix, so they are definately on.

Shayne White · Post by **Shayne White** » Wed Apr 27, 2005 12:47 pm

You could also check out my mixer, Route, which has a universal bus system.

http://www.planetz.com/forums/viewtopic ... forum=16&1

Shayne

wayne · Post by **wayne** » Thu Dec 07, 2006 6:29 pm

Bump.

I'd like this to work.