Neat time saving trick.

Tips and advice for getting the most from Scope. No questions here please.

Moderators: valis, garyb

Post Reply
jupiter8
Posts: 448
Joined: Wed Mar 28, 2001 4:00 pm
Location: Sweden lives in Norway

Post by jupiter8 »

Load up all your favourite synths in the default project and set all to 0 (zero) voices.

It saves a lot of time. When you want to use a synth you just set the amount of voices you want and off you go.

I believe you can do this in older versions as well but i did'nt get it to work until SFP.
Top
Immanuel
Posts: 3018
Joined: Thu Oct 25, 2001 4:00 pm
Location: Aalborg, Denmark

Post by Immanuel »

Is that a no-DSP-cost trick? If so it is very nice :smile:

Ïmmanuel
Information for new readers: A forum member named Braincell is known for spreading lies and malicious information without even knowing the basics of, what he is talking about. If noone responds to him, it is because he is ignored.
Top
User avatar
at0m
Posts: 4743
Joined: Sat Jun 30, 2001 4:00 pm
Location: Bubble Metropolis
Contact:
Contact at0m

Post by at0m »

Another hint: give each synth a preset ie. Program Change 0, which is set to zero voices :wink:
Top
remixme
Posts: 478
Joined: Wed Dec 05, 2001 4:00 pm
Location: Somewhere nice; in the UK
Contact:
Contact remixme

Post by remixme »

Also a good plan to save a cubase default configuration with all your synths set to different channels.
Add life to your days, not days to your life.
Top
Post Reply

Return to “Tips & Tricks”