Page 1 of 1
Boot up
Posted: Sat Dec 23, 2017 4:20 am
by AndyP13
Firstly a big thank you to the people who helped me out after I installed the V7 upgrade - The issue was resolved by upgrading to Windows 10.
After I boot my computer and start the Scope software I get the following (not all the time)

- Scope.PNG (9.77 KiB) Viewed 1597 times
Re: Boot up
Posted: Sat Dec 23, 2017 6:32 am
by astroman
if it's not a random error (some condition triggered the wrong number), this usually pops up with certain 'long delay dsp modules' (residing in the dsp folder), obviously related with specific hardware releases.
I've had it with both 6 and 15 DSP cards and some reverbs (iirc) and could never make a clue out of it.
(the plugins were 'compatible' and others with a similiar setup had no problems running them)
You may check for reverb/delay effects in your startup project - if there are none it's probably an erroneous message.
(I guess it locks you in a loop and you have to restart Scope )
cheers, Tom
Re: Boot up
Posted: Sat Dec 23, 2017 12:04 pm
by garyb
does it start after hitting "yes"?
if so, it's the startup project. it's not a big deal, if it starts.