I'm playing back 16 channels of audio with Cubase through my Pulsar II and needed to add another channel or two.
Seems I can increase the number of channels within Cubase, but as the Big Mixer only takes 8 Stereo inputs via ASIO drivers, I had to rout channel 17 & 18 into an existing bus (in Cubase via the Monitor mixer) between 1 - 16.
Doing so introduces some distortion and crackles into the system. When I mute that channel, it clearly goes away. Seems one stereo bus does not like an additional signal pumped through it (which somewhat makes sense). If that's the case where do I rout those two or extra channels.
I tried routing the signal from ASIO channels 17 & 18 into a regular channel input (non-ASIO input), but that did not seem to work.
Cubase is also not choking, the performance meter says it's OK without overload during playback.
Any suggestions are welcome.
interloper
Cubase Channels
-
interloper
- Posts: 370
- Joined: Sun Mar 25, 2001 4:00 pm
- Location: amsterdam
- Contact:
-
Guest
Subject: Cubase Channels
well my suggestion is not a solution yo the problem but a walk besids it , you can record 8 channels to audioand than delete them and replace the other channels and like that you can go on and on , i know it's not perfect solution but i use it each time i'm running out of dsp (and that's happnes a lot).
well my suggestion is not a solution yo the problem but a walk besids it , you can record 8 channels to audioand than delete them and replace the other channels and like that you can go on and on , i know it's not perfect solution but i use it each time i'm running out of dsp (and that's happnes a lot).