PlanetZ forums - scopeusers.com

Made the Win10 Update to ver. 14393 yesterday and noticed today that the scope Hardware is no longer installed correctly. Before the update everything worked perfectly well. The scope Hardware is not recognised in the device manager. If I try to update the drivers in the device Manager Windows does not accept them.

Any idea what I could do?



Win 10 Pro 64 bit in test mode Build 14393 release 160715-1616
3 * Pulsar 2

You have to disable the signing of device drivers. In command line run these commands:

bcdedit -set loadoptions DISABLE_INTEGRITY_CHECKS
bcdedit -set TESTSIGNING ON

Then reboot

Install the scope hardware and it should run flawlessly.

If you want to reverse the previously mentioned commands do these ones:

bcdedit -set loadoptions ENABLE_INTEGRITY_CHECKS
bcdedit -set TESTSIGNING OFF

Reboot and your set.

This is what I tried first but it didn´t help. It seems I need another approach.

google "disable driver signature enforcement windows 10". there's really only one other way to do it, and it WILL work, if you do it correctly.

this is how Windows is now. you used to just get a warning for unsigned drivers, now you need to disable enforcement first. this affects many graphics drivers, including many for NVidia and others and many printer drivers and other types of drivers as well.

OK , did it finally. Somehow I screwed things up in the beginning and I had a 32 bit Driver instead of a 64 bit. Fortunately I found it after you made clear that it shouldnt be a new Windows problem. Thenit took another two hours until everything was corrected on my System and now I am happy again..

Thanks for your good advice and Kind assistance (as usual)!

sure.
in addition, to make the wave drivers playback work, you may need to restart a couple of services once.

with Scope open, go to "run" and type "services.msc" find WINDOWS AUDIO and right click, choose "restart". do the same for WINDOWS AUDIO ENDPOINT BUILDER

I've get the same problem.
now the scope working only in "test mode" and when I try to reinstall the driver again, i've get the error in the attached picture.
i want to disable the test mode in windows, somebody know what should i do?

Everytime you run the installer you will have to be in test mode.

I'm in test mode...

BoBiS wrote:I'm in test mode...

It wasn't clear for me by your message, sorry. Have you tried to remove the scope drivers and install them again?

After driver uninstall i get deferent error:

Fix it!, i've download new copy of the drivers and it's work great.
many thanks.