Scope & Cubase project advice

[aum7]

Hey there,

sorry if this is a dumb question guys but scope does my head in at times...........

ive been using pulsar 4.5 with cubase SX3.
my scope 4.5 project consisted of the BigMixer where i had the asio in/outs, wave in/outs and pulsar analog in/outs connected and working great with cubase.

ive now upgraded to scope 5 and cubase 5
my old scope project with the BigMixer device wont work or open in scope 5

So....
what devices, mixer type etc... do i need to setup as a project in scope 5 to give me asio, 24bit recording and playback, with wave and analogue in/outs just like i was using in scope 4.5?

i have the Pulsar 1 card with 4 DSP.

thanks

[Mr Arkadin]

You were still using Bugmixer in 4.5? Brave man. Check out the STM mixers and read the corresponding manuals to see which fits your needs. Personally i use STM2448.

[muswell]

i have the Pulsar 1 card with 4 DSP.

thanks

I think but can't say for certain that the pulsar 4 DSPs don't come with ULLI.

[aum7]

yeah the pulsar 1 does come with ULLI

[muswell]

yeah the pulsar 1 does come with ULLI

I'd like to believe you but I think the nays have it:

http://forums.planetz.com/viewtopic.php?f=5&t=28731

[garyb]

well, it doesn't go below 13ms at 44.1k anyway...