Midi Through

firubbi · Post by **firubbi** » Mon Jan 14, 2008 6:49 am

is there any way to use Midi Through as 2nd Midi Out?

thanks a lot.

Shroomz~> · Post by **Shroomz~>** » Mon Jan 14, 2008 7:27 am

No it's not possible. There's no access to the thru port in the routing window, so the midi input signal can't be disconnected etc.

What we need is a universal usb midi module so that we can access usb midi devices from within the sfp routing window.

pollux · Post by **pollux** » Mon Jan 14, 2008 7:43 am

<~Shroomz~> wrote:No it's not possible. There's no access to the thru port in the routing window, so the midi input signal can't be disconnected etc.

What we need is a universal usb midi module so that we can access usb midi devices from within the sfp routing window.

HLD loopback device does the trick quite nicely. I used it to redirect my controller keyboard input straight to a scope synth without having to load a sequencer

nightscope · Post by **nightscope** » Mon Jan 14, 2008 10:43 am

<Shroomz> wrote:What we need is a universal usb midi module so that we can access usb midi devices from within the sfp routing window.

Yes. Just a bit. I could do with one of them!!

ns

Neutron · Post by **Neutron** » Mon Jan 14, 2008 1:47 pm

careful with HLD and sequencers. the problem might be better now but back in the day of p3s you could hear the HLD causing wavering if you make a sequence of identical hihats on 32nd, and play it really fast so it becomes a tone.

then i uninstalled it and the tone became steady.

when using the sequencer to play scope or outboard devices, the effect was a very hard to pinpoint strangeness about the timing.