I am trying to route my Oberheim EDP into Scope, but cannot find a source module which is mono. I always use a stereo kind for the hardware FX, and even my analog hardware synth is mono, as is subjected to a stereo module.
Does anything exist that I am unawre of, and also can a developer make one 4 me, as I see the stereo analog input modules as a waste of space 4 this endeavor.
Honest, I Looked Everywhere B4 I Came Crawling 2 The Z,
Mono Analog Input Module
- Mr Arkadin
- Posts: 3283
- Joined: Thu May 24, 2001 4:00 pm
Dunno if i'm being thick here but why not just use the left leg of the Analog Source module?
Last edited by Mr Arkadin on Sat Aug 04, 2007 2:16 pm, edited 1 time in total.
You can use only one side of it....an analog stereo input is the same as 2 mono inputs. For a nice layout in the project You can use the Source M and Destination M that you'll find in the Devices/Tools folder. They can be assigned to the existing I/O's in the project, for example Left analog in and Left analog out and you will magically see the analog I/O's turn into mono modules with only the remaining port (Right in this case). Then you can rename the Source M and/or Destination M like the ports of the OTB device you want to connect and voilà...if then you save them with your default project you'll have them always.
for example my default project uses a card's left out as a send to an external spring reverb and the right out as a send to a tuner and those outs are made with the modules above renamed as Davoli in and Tuner. The corresponding card's L input carry the Davoli spring return and there is a free mono input for future needs.
You must have the original input modules loaded before you can load the assignable ones which will "steal" the connections.
for example my default project uses a card's left out as a send to an external spring reverb and the right out as a send to a tuner and those outs are made with the modules above renamed as Davoli in and Tuner. The corresponding card's L input carry the Davoli spring return and there is a free mono input for future needs.
You must have the original input modules loaded before you can load the assignable ones which will "steal" the connections.