2nd pulsar II

djsainz · Post by **djsainz** » Mon Jul 09, 2007 1:08 am

Hi,

I am considering getting a second card to expand DSP power, the card is the same as the one I already have installed, Pulsar II with the phono lead octopus.

My questions are:

1) Where can I purchase the connector cable to make them run parallel, unless it already comes in the box (I have mine stored away up in the loft and havent been in it for 7 years)

2) To make it run parallel, do I unplug the addon plate module, thus just making it a DSP card, or can it be left on to use the extra ADAT ports?

3) Does it run fine under Vista? So far it runs ok under vista single card, but no idea what problem 2 cards could cause.

Thanks.

endre70 · Post by **endre70** » Mon Jul 09, 2007 4:02 am

Hi

re 1) order from Soniccore, a scope dealer in your area or search this forum to make your own

re2) Keep the add on plate and get more inns/outs

re 3) Don't know about Vista (run mine under XP pro - lot of tweek pos.) But can't see any problems. Others might add points on this.

Best of luck.

Endre70