How do we route an external synthbox like Roland JV-1010 through Pulsar and into Cakewalk, and how do we get to play multiple MIDI signals at the same time ?
We need help (desperately) !!!
Thanx. [8-}]
Roland JV-1010 and Pulsar
-
Guest
Subject: hm, if i have understood!?
hi,#
i hope i did understand you...
so: you have a masterkeyboard (or keyboard) which you are playing for programming keyboards...yes?
it´s normally connected to pulsar midi-in (hardware!)... the signal flow on the projectwindow from midisource to sequenzerdest, from sequenzersource (seqeuenzer is cakewalk, midi-through has to be enabled!) to the midiinstruments (in your case aou have to connect the sequenzersource with mididest, then connect the hardwaremidiout with your midiin from the JV!).... good luck!
greetings
t.
hi,#
i hope i did understand you...
so: you have a masterkeyboard (or keyboard) which you are playing for programming keyboards...yes?
it´s normally connected to pulsar midi-in (hardware!)... the signal flow on the projectwindow from midisource to sequenzerdest, from sequenzersource (seqeuenzer is cakewalk, midi-through has to be enabled!) to the midiinstruments (in your case aou have to connect the sequenzersource with mididest, then connect the hardwaremidiout with your midiin from the JV!).... good luck!
greetings
t.
