Page 1 of 1
Posted: Fri Jun 02, 2006 8:37 am
by katano
Hi all
I'll be a lucky owner of a second 15 dsp card. how many S/TDM connections should i have with 2 15dsp boards? all five?
thanx
Roman
<font size=-1>[ This Message was edited by: katano on 2006-06-02 10:35 ]</font>
Posted: Fri Jun 02, 2006 8:54 am
by at0m
I think it's common practice to fill them all. It would make for most efficient transfers between the cards. But practically you could do with a single one, unless you're getting "Ran out of STDM connections" errors.
Posted: Fri Jun 02, 2006 9:05 am
by katano
atom,
thanx for the quick reply. I never got "out of S/TDM connections" with my current config with one scope and a pulsar II and 2 S/TDM connections, even if dsp load was about 90%. So I guess 3 connections would be fine to start...
greez
roman
<font size=-1>[ This Message was edited by: katano on 2006-06-02 10:06 ]</font>
Posted: Fri Jun 02, 2006 9:37 am
by katano
thanx stardust...
got some other problems with the magma (other thread here), so looks like two 15dsp cards are a complete waiste of dsp if using in a magma
cheers
roman