Please Help - Saw PW mod MIII+flexor

JLS · Post by **JLS** » Wed Sep 29, 2004 3:10 pm

<a name="planetz-file"></a><a href="http://www.planetz.com/Pulsar/files/mod ... .dev"><img src="/forums/images/file_icon.gif" border="0" alt=" File"> File</a> <a name="planetz-tag"></a>Type: Synth <a name="planetz-tag"></a>Pulsar Version: SFP 3.1 <a name="planetz-tag"></a>Requires: Modular 3 _____________________________________ Hi all

this is not synth only little experiment

please help me make Full range Saw PW mod.

this is example only half pw mod ( lower offset )

Amount 0-100% = only low offset PW
Mod1 0-100% = only half mod range ( sine lfo )

Very thaks help

P.S. sorry english

at0m · Post by **at0m** » Wed Oct 13, 2004 4:17 pm

I think everything is set up correctly, except for the Half Inverter. Half Inverter is a module that outputs only positive signals, so it should be rather used as modulation signal effect, cfr the flexor manual.

Post by **hubird** » Wed Oct 13, 2004 5:11 pm

some time ago At0mic...

JLS · Post by **JLS** » Thu Oct 14, 2004 11:47 am

thanks reply

fixed problem in MorphShapeSynth this forum

remove invertor and half invertor
add diode half and dc blocking filter

Saw + PWmod + diode half + dc blocking filter = Saw PW modulation

Michu · Post by **Michu** » Sun Oct 17, 2004 9:41 am

you could use uni2bipolar iso dc blocking

JLS · Post by **JLS** » Sun Oct 17, 2004 10:26 am

very useful info

thanks Michu