Page 1 of 1
Posted: Wed May 12, 2004 12:18 pm
by eliam
Is this possible with scope? I bought a new converter and want it to be my master clock generator but I don't have a sync plate, so can anyone tell me how to transmit the clock signal through light pipe?
Thanks!
Posted: Wed May 12, 2004 12:37 pm
by snoopy4ever
Yes you can.. just go to Sample Rate settings.. and set the Adat clock source from whatever input you have... Of course use the Slave button .. and you're ready to go.
Snoopy
Posted: Wed May 12, 2004 1:16 pm
by eliam
Ok, that's it? Nothing particular to connect on the surface? thanks a lot!