routing clock through adat

eliam · Post by **eliam** » Wed May 12, 2004 12:18 pm

Is this possible with scope? I bought a new converter and want it to be my master clock generator but I don't have a sync plate, so can anyone tell me how to transmit the clock signal through light pipe?
Thanks!

snoopy4ever · Post by **snoopy4ever** » Wed May 12, 2004 12:37 pm

Yes you can.. just go to Sample Rate settings.. and set the Adat clock source from whatever input you have... Of course use the Slave button .. and you're ready to go.

Snoopy

eliam · Post by **eliam** » Wed May 12, 2004 1:16 pm

Ok, that's it? Nothing particular to connect on the surface? thanks a lot!