Terribly silly question about starting in XTC mode

Nisse · Post by **Nisse** » Mon May 10, 2004 6:54 am

Ive tried searching this forum but came up with nothing.

In the manual it says: Enable XTC mode in the settings, then open the sequencer from the Live bar. . . .

Am I overlooking something embarrasingly obvious here? HOW do you open the sequencer from the Live Bar?

*hides in a dark corner*

at0m · Post by **at0m** » Mon May 10, 2004 7:03 am

You can't. Close SFP, and start VST host / sequencer while keeping fingers crossed. If that didnt work, check out Gonzoft's XTC hints.

cannonball · Post by **cannonball** » Mon May 10, 2004 7:21 am

hi

maybe in the next upgrade

Nisse · Post by **Nisse** » Mon May 10, 2004 7:43 am

Ok thanks guys. Turned out all I had to do was to enable XTC mode, turn off SFP and start the bloody sequencer.

I should know by now not to trust that manual too much. I was going mental from trying to find some secret XTC sequencer button in the Live Bar hahahahaha