Temporarily fixed XTC-Lunabox-problem!!!

Robby · Post by **Robby** » Thu Oct 04, 2001 10:13 pm

I've posted this one on creamware's forum, too, but I thought, maybe not everyone is always monitoring both forums, so here a copy of the article:

Ok, here is what I've just found out, don't know if it works very well, but at first sight, it works!

All of you who were not able to use their lunabox in cubase+xtc listen: I was able to record and play something through the luna box!

Here is how I did it:
I opened the "XTCproject.pro" file located in PulsarappPulsarXTCApp. Now you see a wiring made by Pulsar v3 for your specific setup. I added the z-link source+dest (here without any errors!), added 8 more channels to both ASIO-modules, and connected the 16 new asio-channels with the input/output of the z-link-modules. Save (make backup of that file first!!!) and start cubase, now you have 8 more inputs and can route the output to 4 new stereo busses. I just found out that this trick does it, didn't test it! Try it and report if it works for you!

Cheers,
Robby

GonZoft · Post by **GonZoft** » Thu Oct 04, 2001 11:38 pm

Is there a chance to edit this file if you have only PulsarXTC and not Pulsar v.3?

subhuman · Post by **subhuman** » Fri Oct 05, 2001 7:37 am

I believe you can edit it in Luna software too.

Robby · Post by **Robby** » Fri Oct 05, 2001 8:04 am

Hi GonZoft!

Is there any *.pro file in your XTC-directory? If you have one, I could try to change it to fit your needs. I don't know if it works, but we could try.

Subhuman is right, luna has a *.pro file editor, too. Maybe you could use that software to edit any pro files of your xtc-installation.

Robert

subhuman · Post by **subhuman** » Fri Oct 05, 2001 8:08 am

I haven't tried it, but there is a slim chance Luna can't edit a Pulsar .pro. But that would be kind of silly.

GonZoft · Post by **GonZoft** » Tue Oct 09, 2001 1:54 am

No way. I just tried, but the Luna software crashes when I try to load a PulsarXTC *.pro file. Quite silly this one, you need *.pro files but you can't edit them...
Thanks, Robbie. I'm gonna send you my *.pro file per e-mail.

Cheer.

Robby · Post by **Robby** » Tue Oct 09, 2001 7:54 am

I just tried, but the Luna software crashes when I try to load a PulsarXTC *.pro file.

Be careful! Pulsar crashes, too, if you try to edit _this_ file! I could only load the XTCproject.pro file and did my changes on that one. Did you try that?

If not, I will change one for you if you send it. Just tell me, what modules you would like to be included, I will try to create one. Don't know if I find a solution to use the Powersampler modules, since I only own an Elektra. We'll see.

Robert