![:smile:](./images/smilies/icon_smile.gif)
What do you use to remove frequencies below 30hz on a master setup ?
Do you simply take care of eq on every indicidual channels, or is there a device that does it once for all at the end of the mix ?
Here i often remove F < 180/200 hz on most channels but i still get hi volumes on basses, and anyway i have a signal below 30hz.
Recently I have received the LP of a good friend scope user (he will recognize himself) and on most tracks, freq below 30hz simply do not exist, and the result is very fine to me.
You can imagine that I have made plugins which totally anihilate those infra basses, but i am not yet satified of the results and I am not sure of the opportunity of such things (because it remove too much energy on the whole spectrum, even though only freq between 0 and 31 hz get totally removed (-186dB@30hz
![:smile:](./images/smilies/icon_smile.gif)
Anyone can enlight me on such techniques to remove anything below 30hz?
thanks in advance.
And if you say "hey man, those frequencies are necessary" , well thank you for the advice, i know what you are referring to, but for the moment i'm just looking for answer to the precise question
![:smile:](./images/smilies/icon_smile.gif)
thanks a lot bis....
<font size=-1>[ This Message was edited by: spacef on 2004-05-31 21:32 ]</font>