Cubase VST and Pulsar II

Masada · Post by **Masada** » Wed Sep 19, 2001 5:10 am

Hi,
i would need some help with Pulsar II and Cubase. I need to get all audiosignals from Pulsar into Cubase. Right now i managed to send the Bigmixer's mix out to the ASIO dest. It works fine and i get the Pulsar audio to a Cubase BUS. But how do i set it up if i want all channels from the big mixer to different busses in Cubase so it's possible to add Cubase effects to all Pulsar's sounds?

Thanks!

Micha · Post by **Micha** » Wed Sep 19, 2001 5:23 am

just open the ASIO-module (rightclick) and tell 'em how many channels you want and restart Cubase that it can initialize the additional inputs and/or outputs.
Happy pulsaring!
Micha

Masada · Post by **Masada** » Wed Sep 19, 2001 8:40 am

Thanks!!

But where do i find the outputs from Pulsar that i want to send to Cubase? Should i use the R1, R2, R3 etc outputs from the Bigmixer or? I want to be able to send each channel/synthesizer in pulsar to a single mono/stereo channel in cubase to be able to add unique effects in cubase on each channel.

Sorry for asking

subhuman · Post by **subhuman** » Wed Sep 19, 2001 8:52 am

Depends on if you want to use Pulsar effects on your parts BEFORE they reach Cubase.

If you don't, then just route the outputs of your synths/samplers directly to the ASIO destination.

Air_PoLLo · Post by **Air_PoLLo** » Wed Sep 19, 2001 2:06 pm

It seems that you're rushing things thus forgetting the fact that there are something out there called "manual"

read it, you'll be surpriced how much you can learn!!