Soundforge, WAVs, and VST (by Spirit)

Post by **Guest** » Mon Feb 19, 2001 1:54 am

I have three problems which I can't resolve. I'm hoping someone might take the time to offer a thought:

* When I try to sample PulsarII sounds into Soundforge the CPU peaks out at 100% for about three minutes. After that it's OK and I can sample. Then the next time I want to sample I get the same thing. Why is Soundforge making the CPU so unhappy?

* VST won't record anything direct from Pulsar. VST says it's getting a midi signal in and out and it will also play back notes that I manually "paint" into VST using the tools - it just won't accept anything from the keyboard. I'm sure I'm missing something simple, but what!?

* A lot of the softsynths give me stuck notes, especially the Creamware default synths. Other synths like Saturn, and ZS404 and the three-o-three never stick. Why?

thanks,
Spirit

Post by **Guest** » Mon Feb 19, 2001 8:55 am

Subject: i´ve recorded to wavelab! how did you do it?

hi,
when i was recording to wavelab i had taken the wave destination as input for wavelab. it caused no problems (i remember!)<... so maybe you took the wrong way to record?

greetings and good luck

t.

Post by **Guest** » Tue Feb 20, 2001 5:56 am

Subject: soundforge

I was using wave source / wave destination and going to Soundforge. Super slooooow.

Post by **Guest** » Wed Feb 21, 2001 2:42 am

Subject: yes, but that should work fine!??

hi,
didn´t you say that it won´t work without crackles?
this way should work fine with wavelab - i don´t know about settings in soundforge!°

hm, ....

t.