Intel D875PBZ

Ricardo · Post by **Ricardo** » Sun Mar 07, 2004 8:33 am

Just to let you know, I installed this MOBO hassle free, and with my new 1GB DDRAM it runs like a dream..........

My 3 cards, including a Pulsar 1, are in slots 2,3 and 4, sharing IRQ 9.

Immanuel · Post by **Immanuel** » Sun Mar 07, 2004 9:00 am

thanks

sinix · Post by **sinix** » Sun Mar 07, 2004 9:59 am

Ricardo,

How did you get all of them to share IRQ 9? Did you manually set this?

My card is sharing IRQ 19 with a USB device on the same motherboard.

dland · Post by **dland** » Sun Mar 07, 2004 11:21 am

I am using the same motherboard. I had to disable legacy USB and High speed USB in the BIOS to get the MIDI timing right for Nuendo 2.

Also, I had to play around with card slot ordering, but my system runs like a charm.

------------
WinXP
Pentium4 2.6GHz (non-HT)
Intel D875PBZ motherboard
1GB RAM
GeForceFX5200
PowerPulsar Z-link
UAD-1
TC Powercore
Nuendo 2

<font size=-1>[ This Message was edited by: dland on 2004-03-07 11:22 ]</font>

sinix · Post by **sinix** » Sun Mar 07, 2004 3:55 pm

Dland,

Can you tell me what slots you wound up using for all three cards? I have exactly the same system in terms of DSP.

Very curious...

Thanks

Ricardo · Post by **Ricardo** » Sun Mar 07, 2004 8:24 pm

OOOPs!! You're all going to hate me. Sinix you were correct. When I went back and checked my IRQs the CW cards had been bumped. A very big SORRY for the misinformation.

However Slot 2=SRB, slot 3=P1 and Slot 4= Luna II. I run the i/o on P1.
Even so, it still runs beautifully.

dland · Post by **dland** » Wed Mar 10, 2004 12:30 am

5 (bottom slot) = CW PowerPulsar
4 = blank
3 = Powercore
2 = UAD-1
1 = 2 port Firewire PCI card
AGP = nvidia