Help..Only 4 audio output buses

Ricardo · Post by **Ricardo** » Thu Feb 06, 2003 1:40 am

This is driving me crazy. When I open a project with SFP 3.1c and Cubase SX, all my audio is routed through 4 output busses only. If I reset the device in 'device settings' the buses all work again but there are crackles and pops everywhere. If I save it as a new project, then re-open, the whole thing happens again.

Can anyone help ? Ricardo

[ This Message was edited by: Ricardo on 2003-02-06 01:41 ]

Kenf · Post by **Kenf** » Thu Feb 06, 2003 4:05 am

How many output buses are you expecting? Have you turned them on in the devices VST output menu?
Really need more information.
Regards

Ricardo · Post by **Ricardo** » Thu Feb 06, 2003 6:22 am

I have 5 stereo outputs in this presewnt project, all switched on in VST output box, and all routed to BUS1, BUS 2,3,4,5. I have ASIO source in SFP with 10 channels connected to the mixer (2 for each stereo O/P )
Does this help?
Regards

Ricardo · Post by **Ricardo** » Thu Feb 06, 2003 9:13 am

I've just added another stereo output in SFP and Cubase so that I have one extra (unused).Now when I open the project everything is routed OK. Still sounds crap though. I think I'll do a clean install of everything.

stelibo · Post by **stelibo** » Fri Feb 07, 2003 9:27 pm

I don't know why, but I have the same problem. Hope somebody help, maybe we have done something wrong

stelibo · Post by **stelibo** » Thu Feb 13, 2003 4:58 pm

Repost, it was mistake

[ This Message was edited by: stelibo on 2003-02-13 17:22 ]

stelibo · Post by **stelibo** » Thu Feb 13, 2003 5:29 pm

On 2003-02-06 01:40, Ricardo wrote:
This is driving me crazy. When I open a project with SFP 3.1c and Cubase SX, all my audio is routed through 4 output busses only. If I reset the device in 'device settings' the buses all work again but there are crackles and pops everywhere. If I save it as a new project, then re-open, the whole thing happens again. Can anyone help ? Ricardo

[ This Message was edited by: Ricardo on 2003-02-06 01:41 ]

Did You resolve problem with 4 output BUSSES only? I have the same problem too. What is Your external mixer. I have Behringer DDX3216 with 16ADAT I/O running OS 1.09 and my Pulsar 2 plus SFP is 3.1c too. Everything is fine with SX. It play but no sound in 8-16 BUSSES (4 stereo BUS total of 8 channels)
What is ver. of Your SX. My is 1.01
If You have mail please send me:

stelibo@yahoo.com