Runpep error after changing desktop view from Pulsar to OS

Chadwick · Post by **Chadwick** » Wed Dec 31, 1969 4:00 pm

I switched from Pulsar desktop to OS desktop in View/Setting in Pulsar 2.

Now when I try to start a project in Pulsar I get what's below.

Please help urgently. I use this machine daily for work and can't run Gigastudio without it.

RUNPEP caused an invalid page fault in
module <unknown> at 0000:00fd3320.
Registers:
EAX=00fd319c CS=0177 EIP=00fd3320 EFLGS=00210206
EBX=00600000 SS=017f ESP=0087e60c EBP=022151c0
ECX=022151c0 DS=017f ESI=03486230 FS=0da7
EDX=100a8801 ES=017f EDI=00000000 GS=28d6
Bytes at CS:EIP:
18 33 fd 00 20 33 fd 00 20 33 fd 00 28 33 fd 00
Stack dump:
0054b7c5 03486230 0087e7f4 03486230 024d9d20 0087e6a0 005a5ce0 00000000 80808001 02808080 0087e7c8 005a07e8 ffffffff 10086345 022151c0 ffffffff

Post by **Guest** » Wed Dec 31, 1969 4:00 pm

Subject: edit cset.ini

open the cset.ini and change the value of display mode (or something like that) from 1 to 0.

Mo

Chadwick · Post by **Chadwick** » Wed Dec 31, 1969 4:00 pm

Subject: Thankyou thankyou thankyou!!!

Hey thanks Mo!

There was no display value in the cset.ini file, but I did find a line called 'inscreen'. Seeing as it was under the runpep heading and might be short for initial screen I took a chance...et Voila! Pulsar came up like there'd never been a problem.

I emailed Creamware support urgently yeterday, but still haven't heard back....

Thanks again.

Phew

Rick

Post by **Guest** » Sat Mar 10, 2001 11:52 am

Subject: [APPEARANCE]???

Try to modify the cset.ini as follows (my setup, for example):
[APPEARANCE]
FadeWindow=0
ShowMinIcon=0
GridY=5
GridX=5
DragWindows=1
StandardCursor=0
NoOfScreens=1

It seems at your case whether "FadeWindow=0(1)". That's all.

Mail me your ini file if you want further assistant.

Good lucks,
Long's Studio