I'm about to buy a new PC (for my soon-to-be DAW) and think of following configuration:
- MS-745 ULTRA SIS 745 ATX DDR 333
- AMD Athlon XP 2200+ 1733Mhz TROUGHBRED
- 512Mb DDR 333MHz PC-2700
Any comments?
I don't have Pulsar yet and my question is, can I somehow test this config before I get the Pulsar? What are the best benchmarking testers?
Thanks.
Testing PC configuration
-
spoimala
- Posts: 754
- Joined: Thu Aug 29, 2002 4:00 pm
- Location: Finland
- Contact:
-
Immanuel
- Posts: 3018
- Joined: Thu Oct 25, 2001 4:00 pm
- Location: Aalborg, Denmark
You can not benchmark your way to a good Creamware setup. The most important part seams to be PCI-timing, wich - as far as I know - is not measured by any benchmark.
I have tried a sis735 based mobo, and it did not perform very well - even though it was said to have the highest PCI-bandwith.
The usual safe tip is to get a motherboard with a Pentium chipset. Those usually needs little to no tweaking to get working very good.
Immanuel
I have tried a sis735 based mobo, and it did not perform very well - even though it was said to have the highest PCI-bandwith.
The usual safe tip is to get a motherboard with a Pentium chipset. Those usually needs little to no tweaking to get working very good.
Immanuel
-
spoimala
- Posts: 754
- Joined: Thu Aug 29, 2002 4:00 pm
- Location: Finland
- Contact:
-
remixme
- Posts: 478
- Joined: Wed Dec 05, 2001 4:00 pm
- Location: Somewhere nice; in the UK
- Contact:
-
spoimala
- Posts: 754
- Joined: Thu Aug 29, 2002 4:00 pm
- Location: Finland
- Contact:
-
remixme
- Posts: 478
- Joined: Wed Dec 05, 2001 4:00 pm
- Location: Somewhere nice; in the UK
- Contact:
- garyb
- Moderator
- Posts: 23474
- Joined: Sun Apr 15, 2001 4:00 pm
- Location: ghetto by the sea
- at0m
- Posts: 4744
- Joined: Sat Jun 30, 2001 4:00 pm
- Location: Bubble Metropolis
- Contact: