Have I killed my 2496 i/o Box??
-
JoPo
- Posts: 2306
- Joined: Wed Jun 05, 2002 4:00 pm
- Location: VRRAAaaooOôOooommmh
- Contact:
Re: Have I killed my 2496 i/o Box??
You could bring it to an electronics reparation shop.. They could try to fix it. Of course, it must cost you less than a second hand one...
-
geiger
- Posts: 52
- Joined: Sat Feb 18, 2017 2:55 am
- Location: Bucharest, Romania
Re: Have I killed my 2496 i/o Box??
Hello! I get that all red short flashing.. just connect the box.. open the scope fusion platform, go to settings - routing and click on Hardware IO tab and select the device.. it will be powered and green.
I am not in front of the computer, but I hope this helps
I am not in front of the computer, but I hope this helps
-
ronnie
- Posts: 788
- Joined: Thu Jul 17, 2003 4:00 pm
- Location: Varies Between 30Hz & 20KHz
- Contact:
Re: Have I killed my 2496 i/o Box??
Sorry, no joy 
Must have done that a hundred times.
Must have done that a hundred times."I’ve come to the conclusion that synths are like potatoes, they’re no good raw—you’ve got to cook ‘em, and I cooked these sounds for months before I got them to the point where they sounded musical to me." Lyle Mays
-
geiger
- Posts: 52
- Joined: Sat Feb 18, 2017 2:55 am
- Location: Bucharest, Romania
Re: Have I killed my 2496 i/o Box??
are you sure that the cable is deeply plugged in the luna card and box? It is strange, I had this issue, but solved it by adding the luna z link receive and send in the Hardware IO tab in the settings - routing menu... green light turned on and worked..
-
ronnie
- Posts: 788
- Joined: Thu Jul 17, 2003 4:00 pm
- Location: Varies Between 30Hz & 20KHz
- Contact:
Re: Have I killed my 2496 i/o Box??
Done it all. Different cables. If I push it in anymore the card will come out the front!
"I’ve come to the conclusion that synths are like potatoes, they’re no good raw—you’ve got to cook ‘em, and I cooked these sounds for months before I got them to the point where they sounded musical to me." Lyle Mays