Sync Pllate Setting Up ETC

[garyb]

do you have the short cable that connects the syncplate to the card? there is a small 10pin connector on the card for the cable. just connect it, attach the wordclock bnc cable and start Scope. in the samplerate window, make Scope slave and choose bnc as the source.

[garyb]

no, you shouldn't need anything else....

i suppose it wouldn't hurt to run the installer again.

[pranza]

maybe it is called Src 6 or Src 7?

[gruebleengourd]

maybe it is called Src 6 or Src7?

The BNC sync is Src 6 on my setup running Scope 5.1

[garyb]

that is correct.

sometimes just pushing a button or two will tell what you need to know.