i am lazarus come back to tell you all

j9k · Post by **j9k** » Wed Nov 26, 2014 12:49 pm

I decided to give my old card another shot today... and it worked!!!!!!!!!

I read in another thread where GaryB suggested re-seating the connector plate. So I did that and it's working so far.

go figure

wooo hoooo

j9k

Post by **garyb** » Wed Nov 26, 2014 1:48 pm

well, i might be a wing-nut, but i'm good at passing along information that i've picked up elsewhere...

Mr Arkadin · Post by **Mr Arkadin** » Wed Nov 26, 2014 2:56 pm

The resurrection of j9k.

Welcome home.

darkrezin · Post by **darkrezin** » Wed Nov 26, 2014 3:04 pm

welcome back j9k

I was getting a lot of problems with my cards at one point and some deoxit on the headers before reseating the plate worked miracles.

PlanetZ forums @ scopeusers.com

i am lazarus come back to tell you all

i am lazarus come back to tell you all

Re: i am lazarus come back to tell you all

Re: i am lazarus come back to tell you all

Re: i am lazarus come back to tell you all