Modutf
- Roland Kuit
- Posts: 670
- Joined: Fri Dec 28, 2012 1:42 pm
- Location: NL/SWE
- Contact:
Re: Modular seq
Yes, it works fine
I did midi out from your shell to Mod IV midi in.
Midi in to a drum module and a got a pattern.
I did midi out from your shell to Mod IV midi in.
Midi in to a drum module and a got a pattern.
Avant-electronic composer | synthesis research | lecturer
http://www.rolandkuit.com/
http://www.rolandkuit.com/
Re: Modular seq
When you change values in the mds-8 sequencer does it works ok?
- Roland Kuit
- Posts: 670
- Joined: Fri Dec 28, 2012 1:42 pm
- Location: NL/SWE
- Contact:
Re: Modular seq
Ah, sorry to busy for that. Just tested trigger pulses.
Avant-electronic composer | synthesis research | lecturer
http://www.rolandkuit.com/
http://www.rolandkuit.com/
Re: Modular seq
it works at first load and changes are working.
After saving the modular and loading it again, it works with the actual sequence, but changes aren't working.
I can apply changes only by switching project samplerate master|slave back and forth, or by assigning the modular to a new dsp.
After saving the modular and loading it again, it works with the actual sequence, but changes aren't working.
I can apply changes only by switching project samplerate master|slave back and forth, or by assigning the modular to a new dsp.
Re: Modular seq
Because it is a mdl* can you check if it works when you don't save again the device?
In my system it works even if i save it again. (but i haven't reload it)
* i mean you can make changes and just save the project without saving the device
Do you think i should upload that mod2 shell empty or is it ok that way?
Thanks
In my system it works even if i save it again. (but i haven't reload it)
* i mean you can make changes and just save the project without saving the device
Do you think i should upload that mod2 shell empty or is it ok that way?
Thanks
Re: Modular seq
leaving the mdl as is, it works, tried to save the project, closing scope, reopening scope, loading the project and it works fine.
Then i tried to load the pattern sequencer and i get some dsp load/communication error messages.
We could load it inside another modular shell with specific in/out routing to manage the pattern seq modules.
Good job, at least it works on the xite.
Then i tried to load the pattern sequencer and i get some dsp load/communication error messages.
We could load it inside another modular shell with specific in/out routing to manage the pattern seq modules.
Good job, at least it works on the xite.
Re: Modular seq
Thank you,
yes i'll try to see the pattern sequencer now.
Anyway,
Enjoy...
yes i'll try to see the pattern sequencer now.
Anyway,
Enjoy...
Re: Modular seq
I upload here a modular shell the old Electra. The sequencers are working and the pattern sequencer.
I assigned it to dsp 6.
Enjoy
I assigned it to dsp 6.
Enjoy
Last edited by fra77x on Wed Apr 23, 2014 3:42 pm, edited 1 time in total.
Re: Modular seq
very good.
Re: Modular seq
Modular seqs timing and feeling is best.
Great we have them on xite again!
Great we have them on xite again!
-
- Posts: 1175
- Joined: Sun Apr 04, 2004 4:00 pm
- Location: Brighton England
- Contact:
Re: Modutf
God i would love this!
Cant believe i missed it.
Cant believe i missed it.