4 Pulsar Scope in a same system ?

[Shamk]

I did'n find any old topic about that ...

I remember some people tried, but i don't remember the issue ...

[Ripper]

I think the issue is the PCI overload.

[Shamk]

But if the main goal is adding more inputs without flooding the whole PCI bus by some MV, i hope this could be done !

[Ripper]

But if the main goal is adding more inputs without flooding the whole PCI bus by some MV, i hope this could be done !

Experiments have been made without good results on that. At least that I'm aware of.

[Stevil]

i'm running 2x 6DSP Pulsar II Project Cards on my new system.
based on the "Masterverb Test" the PCI caps 2 MV's before the DSP. 13/15.
I tend to do more signal routing than sound generation/fx so I haven't seen any problems on that front, but 4 might be a different story.
good luck!

[Shamk]

Apparently may run but ...PCI Overload limit...