No Midi-Signals in Cubase/XP

Dolphin · Post by **Dolphin** » Sun May 26, 2002 12:45 am

I have two Pulsar-3.1-Installations (Win98 and WinXP). In Win98 (XTC-Mode) everything works fine. I get Midi-Input-Signals and can send them everywhere (Synths etc.).
When I start Cubase under WinXP (Pulsar in XTC-Mode)I cannot get any Midi-Signal at all. I cannot play any synth. The Cubase-Midi-Indicators don't show any activity.
In both cases I use the same XTC-Project. Did anybody encounter the same problem? How did you solve it?

kiminet · Post by **kiminet** » Wed May 29, 2002 1:20 am

Yes I have a similar problem,but I don´t know how to solve it.The midi works in Sampliude but not in cubase. have the idea
that it has to with the new asio drivers.

Kim

djody · Post by **djody** » Wed May 29, 2002 1:27 am

Try removing and reloading your midi source and save the file.
I had the same with logic audio . After a clean install in win98. In winxp i don't know cos i still use win98 for audio cos i do not get sfp to work perfectly in xp jet.

Laterz

at0m · Post by **at0m** » Wed May 29, 2002 3:20 am

XP: load always as many midi source/dest's as assigned to your hardware in Device Manager.

kiminet · Post by **kiminet** » Thu May 30, 2002 10:08 am

Now my midi works again in cubase (thet worked all the time in Samplitude.I removed 3.1 drivers and replaced them with 3.01(win2000 drivers).3.1 can`t be installed on my system anyway.

Kim