scope 3.06 controls dissapear.

Neutron · Post by **Neutron** » Sat May 25, 2002 10:42 pm

Well i finally gave in and i am now learning DP 3.06, and while its pretty cool and everything, i have yet to get it to save a device i can use in SFP or pulsar3.

I get the surface but no knobs or controls.

the box at the top "go atribute" is set to "surface" for all the controls, but all i can see is some text. the controls that do not show are in the same place in the heirarchy as the text that does show.

this is a new device by the way, not an attempt to convert an old one.

thanks to anyone who can tell me what to do, im sure its something stupidly simple i am missing!

EarlyFirst · Post by **EarlyFirst** » Sat May 25, 2002 11:20 pm

send the surface over I'll have a look or even just one of the knobs.

spacef · Post by **spacef** » Sun May 26, 2002 1:48 am

protect it, your dev is open. or the surface is not optimized ("move" mode gives dotted outline only , your dev is simply not protected).

<font size=-1>[ This Message was edited by: spacef on 2002-05-26 15:55 ]</font>

Neutron · Post by **Neutron** » Sun May 26, 2002 11:17 am

No this is after it does its "protect and optimise" thing

Neutron · Post by **Neutron** » Sun May 26, 2002 11:29 am

Oops spoke tolo soon

now i can get the controls to appear, but they can not be used, just moved around

<font size=-1>[ This Message was edited by: Neutron on 2002-05-26 12:31 ]</font>

Neutron · Post by **Neutron** » Sun May 26, 2002 11:40 am

Doh.. clientarea mode was set to move. i set it to use. now everything seems fine