left- right no run panpot into the scope z link

[nunziata]

Hi, I have a problem of scope. I can not handle channels with pan.
left. right.
What might be?

[nunziata]

up, something

[dante]

Are you saying that when you turn a pan control in your scope project, the sound is still center on your monitors ?

What are you connecting with your z-link ?

Have you eliminated your monitoring setup by monitoring something else ( eg iPod ) to see if that pans, or that the music from it plays in stereo ?

[nunziata]

yes the problem in the soundcraft control room .
i put mic rec on direct out into zlink in and record then i out zlink for master on soundcraft.
but no run pan pot of the mixer , i think.
soundcraft custum 600 ( 16 chanel more 8 bus)
i don't know .

[dante]

So you go from Soundcraft->Zlink->Scope->Zlink->Soundcraft ?

And then theres no pan on Soundcraft ?

What happens if you bypass Scope eg Soundcraft->Zlink-> ->Zlink->Soundcraft ?

Is there still no pan ?

Or have I missed something ?

[nunziata]

You said almost the same thing, you're lost.
without mixer works
thank

[dante]

Yes I'm lost. If it's a mixer problem, then it's not a Scope problem.

[ehasting]

Line Out is pre-panpot but post-fader on the Soundcraft 600
http://www.soundcraft.com/downloads/fet ... des&id=666