Hi folks!
So i dusted my old P2 card and bought the 5.1 software. i have a clean install now and will use it in XTC mode. I got XTC to work flawless
Now to some questions.
1. Can the Minimax be used as vsti/xtc? I read somewhere about copying the file and rename the extention to .mdl?
- where do i put the file for it to load?
2. Can the Modular3 be used as a vsti/xtc?
Also please share some tips on stuff i need to check out free plugs etc are more than welcome
I used this card on my Apple G3 and have not been using it since SFP 3.1/4.5 so i guess theres alot of stuff i missed?
Take care!
J
Clean install Pulsar 2
Re: Clean install Pulsar 2
Free Plugs here come & get em.
http://www.hitfoundry.com/issue_14/mra_mast.htm
Also Higens site
http://www.psy-works.net/
Go nuts
http://www.hitfoundry.com/issue_14/mra_mast.htm
Also Higens site
http://www.psy-works.net/
Go nuts
Last edited by dante on Thu Aug 09, 2012 3:07 pm, edited 1 time in total.
- Mr Arkadin
- Posts: 3280
- Joined: Thu May 24, 2001 4:00 pm
Re: Clean install Pulsar 2
Think a bit of your link went missing dante:
http://www.hitfoundry.com/issue_14/mra_mast.htm
Looks like this needs an update again as a few have gone missing since the youngmusic site went AWOL.
http://www.hitfoundry.com/issue_14/mra_mast.htm
Looks like this needs an update again as a few have gone missing since the youngmusic site went AWOL.
Last edited by Mr Arkadin on Thu Aug 09, 2012 6:59 am, edited 2 times in total.
Re: Clean install Pulsar 2
Ooops. youngmusic gone
damn.
damn.