Can't load big mixer into SFP 5

[fraz]

Hi,

I've got SFP 5 for the software with Scope Pro board and Pulsar 2 -

Ther big mixer device won't load into my SFP 5 project as there is a request for the software key.

I've loaded the all key file for all 3 boards I have (the other one is luna/power sampler which isn't installed)

but each time the import is successful and presumably the key is accepted and then I try to load big mixer again the request for the software key dialog box is shown again

I'm going to get in touch with Sonic Core but before I do was wandering if you folks have had any similar occurences?????


OT

Can the faders on the ST16 mixer be linked so say on channels 1+2 if channel one is lowered the ch. 2 fader will move as well?

Thanks in advance

[garyb]

the stm 2448 will do that.

i'd dump the big mixer. it has phase issues anyway...

[fraz]

OK I can do that..... dump the big mixer that is........

I've not used the 2448 but had a look and got a litttle freaked out and wandered how to use it..... Anyway I'll have another look to see if I can get my head round it so I'll be back to start another thread no matter what...............

[dante]

but each time the import is successful and presumably the key is accepted and then I try to load big mixer again the request for the software key dialog box is shown again
I'm going to get in touch with Sonic Core but before I do was wandering if you folks have had any similar occurences?????

Yep. I just asked for an updated key, got it and then it worked.

[fraz]

I'm happy to let this one go and use the STM series mixers......