How to route SCOPE with Cubase 5

[monoman]

So i just got my Luna card. After using the newest beta for my Windows 7 64bit with XTC Cubases crashes after some while. I want to use SCOPE without XTC now.

How do I route following setup:

1. Analog IN (left) Acidlab 2
2. Profit triggered with Cubase via midi
3. Internal sound of Profit to Cubase (for recording)
4. Acidlab should be recorded with Cubase, too

So just can't get the Analog IN and the internal sound to Cubase. Midi triggering works fine.

I read the manual but now I am stuck. Can someone help me, please?

[at0m]

Just connect your Analog input to an ASIO Dest, as well as the Profit. Enable these ASIO inputs in Cubase.
Connect a Sequencer Source to Profit. Enable that MIDI output in Cubase. Create a Cubase MIDI track, set it to output on that port.

Also, you can connect the Analog input, Profit, ASIO Sources and optionally Wave Sources to a Scope mixer, and route the output of the mixer to Analog Dest - if that's where your monitors are connected to.

This is a rudimentary setup that should get you going!

[monoman]

atom, thank you very much. you made my day

once you got the logic behind SCOPE it's pretty easy.

rock it, atom!

[dante]

A bit late but heres some basics for the audio part :

http://www.hitfoundry.com/issue_01/cubase.htm

I need to add the midi steps to this as well I guess...

[monoman]

cool, dante! i can always use diagrams, i'm more a visual person.
midi would be great, too. i had trouble finding the right audio output. midi was much more self explaining.
anyway, thanks for sharing!

[dante]

No probs, shows me I need to work more on the midi explanations - dont forget to subscribe per below.

[monoman]

email is on the way...