GUI problem with XTCproject.pro

[Wolferich]

XTC is working fine in Scope 5 here but I can't modify my XTCproject.pro anymore because it is not displayed in the routing window when I open it. Is this a know issue and is there already a workaraound?

[cortone]

wolferich,

Are you saying that when you open the XTCproject.pro in non-XTC mode, that you can't see the routing window at all? Or is the routing window open, but empty when you look at it?

Cory

[Wolferich]

Hi Cory

when I open XTCproject.pro in non-xtc-mode the routing window is open but doesnt show any connection. Nevertheless, the project works fine and shows the I/O devices in the Live bar.

wolf

[cortone]

wolferich,

Sorry, haven't encountered this one! The only thing I can think of is that the devices aren't centered in the visible window, and you have to scroll to see them?

Do they appear when you right-click in the Live Bar and choose "open panel"?

Cory

[garyb]

try running the installer again over the top of the old install...

[Wolferich]

Will I have to repeat the modifications for the xtc-mode after a new run of the installer?

Anyhow I had this problem earlier, made a new install and after the first round of modifying, saving, restarting and loading the xtcproject.pro the devices were not shown again.