Splitting cards, authorization issue

[ElmerJFudd]

I have 3 cards (Scope Pro, Pulsar II, and Pulsar I) in a PC.
I've pulled the Pulsar I out and stuck it in a second PC.
I've installed the driver, and am trying to install the 4.0 software?
However, my keyfile (.RGY) will not import properly during installation.
Rather, I get a "Cannot open registry file!" error.
Soniccore have already provided me with the RGY file to install this card separately but I'm stumped.

What may the issue be?

Thanks in advance!

[garyb]

try renaming the file extension to .skf...

[ElmerJFudd]

Thanks for the reply, good idea...
The installer does seem to be looking for an skf.
No luck though, getting the same error when trying to load file.

[garyb]

open the file with wordpad and be sure that the card's serial number matches the serial number in the keyfile....

[Fluxpod]

When i had this prob i had to delete it from the windows known file extensions list.I clicked on "always open with wordpad" once and it showed up as a wordpad document then...the installer couldnt open it.It has to be shown as a Unknown file in windows!Dunno if that helps but it fixed that for me.

[garyb]

good info!

[ElmerJFudd]

Solved,
Refer to this thread,
http://forums.planetz.com/viewtopic.php?f=1&t=27876

Last solution.
a file gets installed on the highest part of the C: drive during the driver installation.
apparently the installer can't over-write this file.
you have to do it manually, then try loading your key file again.