Scope v5 Midi Clock

[Glennk]

Greetings All; Is it just my setup, or is there a general problem in terms of Scope 5 devices not receiving midi clock from Cubase (still on SX3)?

I'm using the same settings that i had in Scope v4 but when i set the clock source on any Scope synth to "External" the synth BPM setting shoots up to 250. The Scope devices don't seem to see SX3's BPM setting at all. On Scope v4, this feature worked fine for me.

Any suggestions?

Regards
Glenn

[Fluxpod]

I have the same problem.I just noticed this.I try to figure out why this is hapening but so far no luck,anyone here that can push me in the right direction?I was pretty busy with ableton but now i could use a little help.

[Fluxpod]

Nobody?I cant figure this out.....

[Glennk]

Hmmm...i don't want to put this in as a bug report if it's just me. Can anyone say that midi clock is working ok in v5?

[nightscope]

I have had clock working from Samplitude to Scope with v5. However, I just tried it out and although I've got the clock stream showing up in a midi monitor neither Solaris or Lightwave v5 will respond to it when external mode is selected.

Song BPM is 90 and external BPM indicator on Solaris jumps to 360 when activated.

Solaris is producing audio but we have no clock and no clue. My present theory is it's all down to sunspots.

ns

[Jah Servant]

I think the midi stuff isn't fully sorted out for V5 as yet

[julian]

it's a bug in the actual RC that will be sorted out in the final release.
we're allready on it

so long,
julian

[Glennk]

You guys rock...thanks.

Regards
Glenn