old lunaII devices in multiple card setup question

Valium · Post by **Valium** » Sun Mar 17, 2002 8:53 am

Hi there

Is there a way I can use my old luna II mixers and stuff in my new setup (Pulsar I and Luna II) if yes how?

thx in advance

at0m · Post by **at0m** » Sun Mar 17, 2002 9:02 am

Just load the device, but make sure you got it on disk. If it's registered to a card which isn't registered yet, PulsarOS will ask you for your card and key.

at0m · Post by **at0m** » Sun Mar 17, 2002 9:02 am

Just load the device, but make sure you got it on disk. If it's registered to a card which isn't registered yet, PulsarOS will ask you for your card and key.

Valium · Post by **Valium** » Sun Mar 17, 2002 9:51 am

Hi thx for the reply,

I was wondering, if I copied all my old luna devices into c:pulsar3devices.. could this make it a little easier on myself?

Just thinking of the easiest way to gain acces to old devices / projects.

Will this work if I do the same with my old projects?

thx and greetz

at0m · Post by **at0m** » Sun Mar 17, 2002 9:56 am

Hi West-side

Yup, just make a folder "Luna2" like there's a "Pulsar2.04" folder in the "Devices" folder.

For projects I don't know... (I don't have Luna)