Use 3rd Party ASIO AND Pulsar2 XTC in one sequencer!!!

Tips and advice for getting the most from Scope. No questions here please.

Moderators: valis, garyb

Post Reply
User avatar
at0m
Posts: 4743
Joined: Sat Jun 30, 2001 4:00 pm
Location: Bubble Metropolis
Contact:

Post by at0m »

Second generation CW cards run XTC in non-ASIO mode. This is also why Pulsar1 gives 'Cannot run in Accelerator Mode' pop-up.

This was confirmed by Ingo Raven (from Creamware) on yahoo groups. I quote:
> So I can have my MOTU 828 as my ASIO driver and still load XTC Instruments
> into the Pulsar II card ?
>
> Regards,
>
> Andy
> http://www.subsymphonic.com

Yes.
Ingo,
CreamWare
I'm using an all-Creamware soundcard setup, but it may interest some of you.

atomic.

_________________
<font size=-1>He who always lays on the floor will never fall down.</font>

<font size=-1>[ This Message was edited by: atomic on 2002-03-13 18:00 ]</font>
Post Reply