strange modular behaviour

fidox · Post by **fidox** » Wed May 30, 2007 4:10 am

hi !

i have some strange behaviour under modular :

didn't notice that before , until i ordered flexor 3 and i wanted to load modules into empty modular window, but problem isn't in flexor 3,

i have do fresh install of winxp and scope, modular 2 and 3 installed,
when i load empty modular window and i want to load modules, i can't see them, but i see that they are loaded, cause there's hdd activity, dsp meter activity, modular window is growing , but i can't see modules,

i don't have problems when loading patches, i can see those modules inside with no problem, even if i add there other modules i can't see them again....

someone have same experience with this,

i remember before that i was able to create my own patches with no problem....

thanks in advance !

matej

alfonso · Post by **alfonso** » Wed May 30, 2007 4:24 am

When you select them in the drop-down menus just drag them inside the window moving the mouse a bit, just clicking on them like you do for loading devices in the sidebar is not enough.

i hope the problem is just this one...I remember someone else had the same behaviour and this was the solution

fidox · Post by **fidox** » Wed May 30, 2007 4:31 am

YES !!!!!!!!!!!!!!

that works !

i'm gonna drag and drop myself somewhere next time

thanks alfonso

matej