Solved(for now) No MIDI going into Logic PC

paulrmartin · Post by **paulrmartin** » Sun Sep 03, 2006 2:41 pm

I checked my environment in Logic, all the right connections are there. I have been using the SAME Scope Project for YEARS and this is a revolting new development. MIDI does work in that blasted Cubase but I will not switch!(so don't mention it, ok?)

The only thing that is new in my computer is a new HD with a second raid controller (because it's my 3rd SATA HD).

Please help

Oh yeah, I did the win.ini thing as well

_________________
Are we listening?..

<font size=-1>[ This Message was edited by: paulrmartin on 2006-09-11 14:38 ]</font>

paulrmartin · Post by **paulrmartin** » Sun Sep 03, 2006 4:47 pm

Never mind. I think I scared my cards by clicking "Enable XTC mode" and unchecking it...

I have no idea why it suddenly came back...

Post by **hubird** » Sun Sep 03, 2006 5:19 pm

just bad luck Paul

(you could ad 'solved' to the subject...

).

paulrmartin · Post by **paulrmartin** » Sun Sep 03, 2006 6:30 pm

You're absolutely right, Huub

Done!

valis · Post by **valis** » Sun Sep 03, 2006 9:51 pm

for future reference Logic enables/disables its midi ports in the [Logic] section of C:WINDOWSwin.ini

paulrmartin · Post by **paulrmartin** » Mon Sep 04, 2006 6:13 am

On 2006-09-03 15:41, paulrmartin wrote:

Oh yeah, I did the win.ini thing as well

valis · Post by **valis** » Mon Sep 04, 2006 9:44 am

lol. /me wakes up.

paulrmartin · Post by **paulrmartin** » Sun Sep 10, 2006 9:19 am

Ok. MIDI is not going into Logic at all.

I am starting to think it has something to do with me srewing up my second raid controller(I had a third SATA drive installed so I needed another RAID controller).

Is that possible?

valis · Post by **valis** » Sun Sep 10, 2006 10:18 pm

Scope sees midi input (in midi monitor)? This is routed to a sequencer destination that is available in logic, but not being 'seen'? Did you go to the clicks & ports layer in the environment and attach a monitor directly to the input there to see if Logic overall is getting data?

paulrmartin · Post by **paulrmartin** » Mon Sep 11, 2006 2:37 am

Logic is not receiving anything as far as MIDI is concerned. My environment(clicks and ports) is configured correctly.

valis · Post by **valis** » Mon Sep 11, 2006 12:58 pm

Are any other apps able to recieve midi (midi-ox for instance)?

paulrmartin · Post by **paulrmartin** » Mon Sep 11, 2006 1:38 pm

I added a second Sequncer Destination to my Scope project and MIDI goes to Logic fine now....

Go figure....