Cannot make Group Chanel in STM 2448

Compact · Post by **Compact** » Wed Aug 09, 2006 10:44 am

I even not know this make.Possibly whether it To unite Two channels in one .
I ask the help .Thank .Shalom

H-Rave · Post by **H-Rave** » Wed Aug 09, 2006 11:13 am

at the bottom of the mixer there are two boxes(above the channel number)with - these are mute and channel grouping, click and hold,move your mouse up, choose a number for the channels concerned, the left box is muting,the right is grouping.

Compact · Post by **Compact** » Wed Aug 09, 2006 12:27 pm

Thank you!!!

As I see it does a grouping of fader of loudness

But how to make so that I could operate two channels by means of one

It is needed for me what. kick (channel 1) and bass (channel 2), to take in one channel for work with him one

how in Cubase Group channel
that to do work one Plug-in on two channels

Excuse for my inglish

Compact · Post by **Compact** » Thu Aug 10, 2006 9:42 am

not possible ;(

at0m · Post by **at0m** » Thu Aug 10, 2006 11:33 am

Just send them to a bus, if needed you can disengage them from the mix (click green button to grey), then feed the output of that bus back to a channel which goes to the mix.

voidar · Post by **voidar** » Fri Aug 11, 2006 4:29 am

Sounds to me like you need to use the Bus-feature also.

After assigning the two channels to a bus, press the green-buttons on the channels to remove them from the main mix.

Compact · Post by **Compact** » Sat Aug 12, 2006 2:03 am

Many many thanks This works

))))))))))

SHALOM