ADAT i/o of pulsar2

firubbi · Post by **firubbi** » Fri Jul 21, 2006 7:02 am

hi,
cant figure it out which two are in and which two are out! they all look just same.
thanks

H-Rave · Post by **H-Rave** » Fri Jul 21, 2006 7:25 am

you adat ins are the sources and your out are the destinations.Try putting something into it you'll soon figure it out.

astroman · Post by **astroman** » Fri Jul 21, 2006 7:57 am

the inputs are dark and the outputs show a red light

cheers, Tom

ali · Post by **ali** » Fri Jul 21, 2006 8:34 am

Please refer to page 3 of the PDF manual under connectors

ADAT in 1 (A)
ADAT out 1

ADAT in 2 (B)
ADAT out 2

<font size=-1>[ This Message was edited by: ali on 2006-07-21 09:35 ]</font>

firubbi · Post by **firubbi** » Fri Jul 21, 2006 9:33 am

Thanks all.
so the 1st one from left is IN-A

thanks again.