Interface Cable and Asio question

gufo · Post by **gufo** » Sat Jul 01, 2006 10:19 am

Hi
Is possible to change the interface cable? (i have a RCA in/out and i want to buy a Balanced I/O cable)
Where I can buy it.

I have 2 ADA8000 connected via ADAT but Nuendo 3 (Scope 4.5 Asio drive) show, in the ADAT A, only the channels 3 to 8. Why?

Thanks

astroman · Post by **astroman** » Sat Jul 01, 2006 11:00 am

I don't have a sequencer but I remember something that said asio 1+2 are reserved by default to the main stereo sum.
If you have evenly connected asio1 to adat1, asio2 to adat2 etc then the first 2 (external) connections would be ignored.
Connecting adat1 to asio3 and so on should give you all IO channels - dunno if that can be re-configured in Nuendo.
At least this is not related to balanced/unbalanced connections.

cheers, Tom
btw that box of Rio Caribe Superiore roasted cocoa beans (beneath my monitors) is from your country - delicious

<font size=-1>[ This Message was edited by: astroman on 2006-07-01 12:01 ]</font>

H-Rave · Post by **H-Rave** » Sat Jul 01, 2006 11:05 pm

Have you configured Your Vst Connections correctly

Post by **garyb** » Sat Jul 01, 2006 11:26 pm

only asio connections are visible inside nuendo. to connect them to adat you must use the routing window. in vst connections(within nuendo) you must enable the additional asio i/o if you want to use more than the first 2.

<font size=-1>[ This Message was edited by: garyb on 2006-07-02 00:27 ]</font>

samplaire · Post by **samplaire** » Sat Jul 01, 2006 11:39 pm

On 2006-07-01 11:19, gufo wrote:
Hi
Is possible to change the interface cable? (i have a RCA in/out and i want to buy a Balanced I/O cable)
Where I can buy it.

Read this