How do I get the pulse osc to output at a 10% duty cycle?

Post by **irrelevance** » Tue Dec 20, 2005 6:47 pm

Seems that the pulse modules do not go below 25%?

Post by **irrelevance** » Tue Dec 20, 2005 7:00 pm

I just put the output through an inverter, therefore making 90% = 10%. Does this sound logical?

steffensen · Post by **steffensen** » Wed Dec 21, 2005 1:14 am

sounds about right to me! but what do i know..

Post by **irrelevance** » Wed Dec 21, 2005 4:28 am

Thing is I've read that if the duty cycle is converted to a fraction then this and the integer multiples of this will be the harmonics that will be missing.
So just inverting a signal isn't gonna change it's harmonic spectrum, as 1/10 is the same as 9/10 so i'm fooling myself it seems.

at0m · Post by **at0m** » Thu Dec 22, 2005 8:24 am

Tried Flexor's Hard PWM shaper? You don't even need a PWM osc for that, any stream would do

Post by **irrelevance** » Tue Feb 21, 2006 11:30 am

Kool I'll check it out thx at0m

<font size=-1>[ This Message was edited by: irrelevance on 2006-02-21 11:30 ]</font>