ASIO Scope driver not found, what to do if

[Nestor]

You may have a SCOPE driver related problem, you can also have some motherboard driver problems, which are so complicated that the best to do is reinstalling everything, it’s much shorter BUT, you may have just forgotten to activate your ASIO Scope drivers. Here is what you have to do:

PROCEDURE TO ACTIVATE ASIO SCOPE DEDICATED DRIVERS IN YOUR SEQUENCER:

1- go to your “C” drive
2- go to “Scope” folder
3- go to “App” folder
4- go to “IOEnabler”
5- open “IO Enabler.exe”
6- tick “Enable ASIO Drivers”
7- go out with “Save”

Good luck!

[astroman]

well done, Nestor

[Nestor]

Well, my problem was driver related, but not SFP related. Nevertheless, this tip save ChampionSound life

[ChampionSound]

That's right

[igge]

That would be all nice and dandy, if IOenabler.exe could actually start on WinXPpro SP2. I recently had to swap my dead motherboard for a new one, resulting in the Asio-drivers being gone.