S.O.S please help !!!!

gelder_1 · Post by **gelder_1** » Sun Nov 18, 2001 1:19 am

yesterday i shut my pc as usual and wtill than everything was working fine.

this morning i turned the pc on , and he couldn't find the pulsars driver (bla bla bla found new pci multimedia bla bla bla) it seems he lost the driver , i tried give him the original cd-rom from CW but he can't recognize my board (the driver you selected was not written for this ...bla bla).

i tried the pulsar V 3.0 drivers which failed too.

my board is pulsar II and i'm in big panic please help me !!!!!

shloomper · Post by **shloomper** » Sun Nov 18, 2001 1:33 am

Just a thaught,
How about restarting into command prompt,
(f8 pressed during startup)
than in C: type "scanreg.exe"
than "view backups", choose a backup you want to restore and - restore.
hope it helps
if not,,, may-b u should backup your projects & presets, uninstall pulsar, than remove pulsar from device manager, refresh,
install driver (from cd), than restart & install pulsar

<font size=-1>[ This Message was edited by: shloomper on 2001-11-18 01:38 ]</font>

Signal X · Post by **Signal X** » Mon Nov 19, 2001 8:33 am

Yo Gelder, I hope you remember , , ,
The only thing that comes up in my mind is that the Pulsar board was unplugged from the PCI slot.
Try to open your computer and and make sure the Pulsar is inside the slot correctly.

gelder_1 · Post by **gelder_1** » Thu Nov 29, 2001 7:31 am

hey vic , sure i remember , how are you ?

solved the problem , it was your solution together with wrong driver....
now it's working , 'till i'll backup everything , format my harddrive and install the new 3.01

thanks for your help.

Signal X · Post by **Signal X** » Thu Nov 29, 2001 4:21 pm

Yo, I'm glad you solve it.
Here anytime to help

[email protected]