seq won't load asio drivers

eliam · Post by **eliam** » Wed Mar 16, 2005 12:23 am

Everything seems fine with scope, the asio modules are in the project but nuendo says "can't load asio drivers".

I have reinstalled scope a couple of times as well as nuendo, without success...

Any hint as to how to fix this?

Thanks!

at0m · Post by **at0m** » Wed Mar 16, 2005 8:58 am

Normally, ASIO is installed with the client, so Nuendo. When the problem presents itself, I've always gotten away with it by re-installing the latest update of [Cubase].

Also, have you tried opening Nuendo with Pulsar set to samplerate --? Slave SFP to something that has no incoming clock, and Nuendo will, again, say it didnt find any drivers. That also resets ASIO, but on another level than the re-install.
For example, after a Nuendo crash when SFP thinks Nuendo is still using the drivers and upon re-opening Nuendo complains it doesn't find ASIO.

More than that I can't think of :/ Good luck, Eliam!

Post by **garyb** » Wed Mar 16, 2005 4:13 pm

reinstall the scope drivers in the device manager...

eliam · Post by **eliam** » Wed Mar 16, 2005 5:12 pm

Thanks for the tips, but neither of your suggestions worked... I'm clueless here... I guess I'll reinstall my system from scratch unless I fix it quickly...

Thanks anyway!

Music Manic · Post by **Music Manic** » Wed Mar 16, 2005 10:28 pm

This constantly happened to me when installing scope v4.0.
I got project without mixer too.
Tried re-install then got no registry key found error.
Can't remember how I got around it bit I didn't start Scope when it asked.
Think I re-installed drivers then scope exe.

valis · Post by **valis** » Wed Mar 16, 2005 10:43 pm

Perhaps you've reached the '10 Entry Limit'?

http://www.rme-audio.com/english/faq/10entrye.htm